Cutting off the right side slide release from the ambi part eliminates that friction, which is most prevalent at the wall of the trigger pull They also changed the optic system which looks like the nocturne setup You can actually see the right side of the frame push out a little as the trigger pull completes and the trigger bar rubs against the ambi release.
Ambie Bambii's Age, Bio, OnlyFans, Career, Net Worth
My recent experience with a wilson was disappointing
One cracked before i completed installation, the replacement was so spongy that pushing the right hand side wouldn't completely disengage the left side
These weren't the shielded ones mind you, but these ambi ones were just mim'd. Edited february 10, 2024 by 392heminut Flipping the ambi safety to off will pinch the palm of my left hand I don’t have this issue with my 1911’s but the 1911’s don’t have the fat grip of the prodigy.
My 5” prodigy has run 100% except for an old batch of reloads from last year They run through my glocks fine but there isn’t quite enough crimp on them to make the prodigy happy There is an oocassional ftf with these loads Everything else runs like a champ
The chamber is a little tighter than my glocks
Wilson high wide ambi thumb safety I was thinking of replacing it with a single sided thumb safety, but before i do i just want to make sure i'm not going to need it Can anyone think of a situation where you would need an ambi safety in competition? Since the grips (hogue fancy hardwood) were not very expensive i decide.
So the ambi safety isn't a standard configuration Is it possible to change to single side, if no ambi extended safety exists? Some of the criticisms of the shadow 2 compact was lack of firing pin block and not being a decocker So it was almost perfect
And is what makes it a shadow
So now with whatever wisdom this is, they added the firing pin block and ambi decock levers
