I probably did not get enough pictures or take enough botes, but here goes In front of walton lake (no relation as far as i know bw!) on a propane run To start off, i replaced a holley 4bbl carb mounted on an offenhauser intake
Cj Miles : ModelsGoneMild
Is it more carb than.
Ok, last week had a rough night and ended up blowing the fusible link that comes off the solenoid
Went back the next morning and fixed that, and when jeep fired up i noticed my fuel lines were cracked coming off the filter (stock 1 inlet, 2 outlet) Well you know on a stock cj how the oil from the rear port/hole in the valve cover gets sucked up into the air cleaner & the filter gets full of oil after a. Scan of provided installation instructions If you're looking for a smaller 5 speed you may want to consider an nv3500
They came behind 4.8l engines I adapted it to the d300 using a new input. Dedicated to complete builds, rebuilds and restoration threads from start to end. Posted this in another heading, but not sure if it was good place, so i will ask here too.got my gr8tops rear window seal to install my new rear slider
I want to make sure i put seal on in correct direction, not trusting how old one was installed because it did leak
From what i've seen, no soft doors will mate up to your hardtop The yj soft uppers are square on the rear corner and the bestop are round but are bigger than steel doors as they overlay the soft top Yj hard doors will fit a cj perfectly They are dimensionally exactly the same.
