I went ahead and lubed the bearings with the arp lube that came for the studs and then followed the arp torque procedure from jgs to torque them all down Also the t3 backside limits it up top. Please join the forums and get connected with almost 11,000 members that are constantly trying to push the envelope of the ka within the market
Kat Von D reveals shocking amount of time she's spent blacking out her
I currently have a ka24det with a felpro headgasket on a sr20det t25 running 10psi of boost
I'm about to build another ka24det and was wondering how much boost/power is the felpro paper type headgasket good for (apparently i heard 400)
I know people always bash on felpros and i was planning to run a multiple layer steel type cometic hg, but i also hear bad stuff about them New kat dyno z31 turbo 8psi by atomgrimus » sun feb 08, 2015 5:41 am im like 2 years late here lol, i got a t3 z31 turbo, i did research and it says on other forums that this turbo can only hold up to 6psi idk how true that is. The operation of the swirl control valve extends the torque curve of the engine It does this by essentially providing two seperate intake velocities and torque curves that are switched, overlaying the curves as a single extended profile
The scv are operated by a proprietary load and rpm based switching algorithm The ka24e ecu uses seperate maps for each state of the scv (open or closed. I bought a sandwitch plate with taps for oil pressure guages and whatever you want to install. I would imagine most first time t25 setups are not gonna have this kind of $$$ invested in the fuel setup
I know i will be using this to do my fuel lines on my 1jz swap
Its nice to finally see the correct way to convert your stock hard lines to an.
