My tranny gasket was about gone so i replaced it On the inside, on the rear cover is gm1, over about 2 is g12, and just below that is 6260233 I dropped the pan, changed the filter and gasket and then replaced the pan
Transgender teen Brittney Kade dreams of becoming a model after
I put four qaurts dextron/mercron iii tranny fluid into it
Started motor, let it get hot, shifted through all gears and checked the fluid level.
In addressing some problems in a recently acquired 87 el camino, i pulled the driven gear bullet to replace leaking seals At least half a quart of tranny fluid poured out If my memory serves me correctly, when i have pulled this speedometer gear housing in the past from other 350s, i only. This allows me to lower the car back down after the engine/tranny is out most of the way and gives needed clearance over the front of the car
It really helps to have a couple of buddies to help. The tranny is marked as This tranny is about 1 1/2 years old and probably doesn't have 1500 miles on the rebuild It is an '89 model
I had it completely gone thru with the typical extra clutch packs, corvette servo, new reaction shield (?) and a transgo shift kit, etc
It was built by the highest regarded. Read that on one of the oil analysis data links here somewhere I use mobil 1 because the synthetics take the heat better, i'm sure amsoil is similar Basically, if the tranny fluid swap doesn't increase your performance, might as well go for longevity instead.
Transmission cooler sizes are endless Some would say bigger the better Well i can't see that helping the engine cooling Is there some rule of thumb for sizing
Then there are tube and fin.
I've hear 400 turbo transmission and 700r transmission Looking to buy a new one rather then a rebuilt one It would be used as a daily driver and cruiser. Hi, could someone help out with the numbers from a 350 tranny
I'm just trying to find out what year it is for future reference On the outside on both sides is 3t
